Remove most coatings down to white metal, grafitti clean up, and paint surface preparation
Experiment with the various pressures on your machine and the grade of sand to determine which will give the best results
SPECIFICATIONS:
Carbide tip.
Maximum Flow: 8 GPM
Maximum Pressure: 3650 PSI
Maximum Temperature: 190 degrees F.
24" wand
25 feet of polybraid hose
INSTALLATION:
(1). Install male pipe thread into the outlet of trigger gun. If using teflon tape as a sealant, make sure to get no tape inside the pipe, as it may clog the high pressure water nozzle
(2). Insert the probe into bag, bucket, or pile of sand. MAKE CERTAIN THE OPPOSITE END OF THE SHORTER TUBE IS NOT COVERED BY SAND. This is a breather tube and performance will be affected dramatically if this tube is obstructed
(3). Turn adjustment knob fully clockwise for maximum sand flow