Product Overview
A 
product.
product.- Draws from pre-mixed solution
- Powered by compressed air and electricity
- Repeat cycle timer
- Quick-change pump
- Supports up to 3 twin-line stainless steel nozzle assemblies
- Up to 100 ft. (30.5 m) total distance between control box and nozzle(s) (distance does not need to be evenly distributed)
| COMPRESSED AIR REQUIREMENTS | 40-80 psi (3-5 bar) with 5-10 cfm (141-283 l/min) |
|---|---|
| WATER REQUIREMENTS | 10-100 psi (0.69-6.9 bar) Backflow prevention is required – consult local plumbing ordinances for more information. |
| LIQUID TEMPERATURE RANGE | 40-100ËšF (4.4-37ËšC) |
| ELECTRICAL REQUIREMENTS | 120 VAC at 60 Hz, 2 amps (GFCI protected outlet) |
| OPERATING VOLTAGE | 120 VAC |
| CHEMICAL COMPATIBILITY | Chemical products used with this equipment must be formulated for this type of application and compatible with unit materials and pump seals. For more information on chemical compatibility, consult the manufacturer or SDS for your product or contact our customer service department. |
*Dilution rates and flow rates given are based on chemical with viscosity of water and factory air pressure settings.
| POWER TYPE | Compressed air, electricity |
|---|---|
| CHEMICAL PICKUP TYPE | Draws from pre-mixed solution |
| NUMBER OF PRODUCTS UNIT CAN DRAW FROM | One product |
| SUCTION LINE LENGTH/DIAMETER | 8 ft. (2.4 m) hose with 3/8 in. (9.5 mm) inside diameter |
| FLOW RATE* | 2 gal/min (7.6 l/min) |
| PUMP SEALS | Santoprene, Viton, or Kalrez |
| TIMER OPERATION TYPE | Repeat cycle |
| COVERAGE AREA | One nozzle: up to 9x5 ft. (2.7x1.5 m); Two nozzles: up to 8x4 ft. (2.4x1.2 m) at each nozzle; Three nozzles: up to 6x3 ft. (1.8x0.9 m) at each nozzle |
| FAN TIP | One nozzle: ST80200; Two nozzles: ST80100; Three nozzles: ST8060-1/2 |
| NOZZLE TYPE | Twin-line stainless steel assembly (GK7T) |
| NUMBER OF NOZZLES | One control box can support up to three nozzle assemblies |
| DISTANCE FROM NOZZLES TO CONTROL BOX | The combined distance between the control box and the nozzle(s) must equal 100 ft. (30.5 m) or less |
| TUBING/FITTING SIZES | Designed for use with 1/2 in. (12.7 mm) outside diameter tubing between control box and nozzle(s) |
