Questions? Feedback? powered by Olark live chat software

Hot2Go® RGV40H12 25 GPM Gas-Vac Water Transfer System - 688cc Honda

HydroTek

(No reviews yet) Write a Review
$10,821.12
SKU:
RPV40H12
Weight:
460.00 LBS
Adding to cart… The item has been added

Product Overview

 

Hot2Go® RGV40H12 25 GPM Gas-Vac Water Transfer System - 688cc Honda Engine

Capture and transfer up to 1500 gallons of water per hour from up to 350 feet away. The RGV40H is a powerful water capture and transfer system that is gas-engine driven and will recover water from over 350' away. The unique polyethylene separation tanks are non-corrosive, weigh less than others, and have full access to the inside for periodic maintenance with a quick lift-off lid. Open the large 1-1/2" valves to dump sludge / solids that collect at the bottom. Each separation tank has an automatic transfer system which pumps the water out to your bulk tank, landscape, or sanitary sewer where permitted. A debris filter and air filter protect both the transfer pump and blower from debris.

The RGV is a powerful water capture and transfer system that has a gas engine driven blower and will pick upwater from over 350' away. The unique polyethylene separation tanks are non-corrosive, weigh less than others, and have full access to the inside for periodic maintenance with a quick lift-off lid. Open the large 11/2" valve to dump sludge/solids that collect at the bottom. Each separation tank has an automatic transfer system which pumps the water out to your bulk tank, landscape, or sanitary sewer where permitted. A debris filter and air filter protect both the transfer pump and blower from debris.

Features

  • No outside power source required. Requires Minimum 650CCA battery Not Included
  • Vacuum and pump out simultaneously and automatic, no loss of suction or lost time dumping tanks.
  • Recovers up to 1500 GPH with 350' total hose length - Use with one or two pick up devices.
  • Light, non-corrosive vacuum tanks with lift-out baskets that collects large debris
  • Large 8-gallon fuel tank sits in frame base while keeping small footprint
  • Air throttle valve for precise control of air flow using different pick up devices or varying hose lengths
  • Requires 2" Vacuum and discharge hoses. For cold water or hot water recovery up to 200F. Consistent air induction at the pickup is needed to prevent hydraulicing.
  • 50-State CARB Compliant

Note: Not for use with waste streams with high foaming soaps.
*Specifications subject to change without notification and may vary due to ambient conditions.
**Not intended to be fully immersed under water, consistent air introduction at the pickup is needed to prevent hydraulicing

 

dsfagrf.jpg

 

Reviews

(No reviews yet) Write a Review